Image source: http://www.haceracuario.info/blog/wp-content/uploads/2017/02/como-hacer-un-acuario-casero-para-peces6.jpg
We will use 2 small side, which will make 4 inches (9 * 7/8) inches. The bottom of the tank 4 "by 6". And the larger side, will have 6 "10". These crystals I will acquired in a company that sells cut crystal.
It is not a company that manufactured parts, because those are the workshops and charged them too expensive for these crystals. The value of these crystals is around 1.30 Dollars. It is very economical and it would be very good because it could manufacture enough betteras fish tanks. Let's see how we produce our fish tank.
To build this fishbowl we will need tape and white or transparent silicon. The tape is to place it on the piece of glass. In the background we will place some pieces, to grab our crystals. What we do in this way.
This tape will grab the pieces going up. Now we proceed to turn it so that the tape is below. Let's take the silicon, which can be of this small or this big. The first thing we do is put the silicon in these edges in the smaller sides.
But this way, where you play for that not much agglomerating. The large side also we are going to put tape. After hitting the tape, we will turn the glass so that it is below. Let's put the silicon, this time we'll do it in a "U".
First step, let's grab this glass going up the glass bottom of the tank. Where we put the silicon. Let's put it well even and grabbed the tape that is already in place. We bring this part, which goes under the bottom side of the glass.
We put good even. The silicon will not dry immediately so it will give us time to assemble We review that right this well and proceed with the other 2 pieces. Remember that small side go above the bottom, which was where we put the silicon the first time. We put good partner, the last piece that is going to put the large side.
Remember that goes flat on the surface of the table, bottom side of the glass. We aligned and joined. The we verify they are well placed and set all tape. Now we will give you 20 minutes to apply the silicon that will seal.
It's been 20 minutes and the silicon has dried enough. We will proceed to seal it with silicon. For this we will make a cut to the case in the finest part, so much silicon can not leave. We will do so carefully starting from the corners.
We must make it soft so that each party receives the necessary silicon. And we apply the silicon. Here soap water, which which we will moisten your finger to slide the silicon. We will spend a wet finger to all the silicon that apply.
While support for the silicon sticks well to the corners. We clean the silicon to stay stuck and continue. Already stuck entire silicon. Now let stand at least 1 hour to dry the silicon and can test.
If we discover any leaks after trying it, then we dry it well and repaired with silicon. After spending more or less 1 hour, we will proceed to remove the tape. I must point out the danger of glass, since they can be cut, so children should get help from parents. The last serious step, take a sandpaper disc and pulirle edges in this way.
Sanded and our fish tank, without its danger that we can cut. It was all for now. Remember to subscribe, give I like to videos and visit us in our social networks. Until next time..
Tidak ada komentar:
Posting Komentar